Maytag Maxima Steam Washer Door Locked

When using one of these cycles the door will remain locked until the cancel button is pushed.

Maytag maxima steam washer door locked.

The door lock led light will blink. Remove the lower access panel. The door may immediately unlock. Our maytag maxima steam washer has a flashing yellow light next to door locked the door won t open and the machined cannot be turned on.

The washer will go into a hold and drain routine for 8 minutes. There was an answered by a verified appliance technician. The door should unlock after 60 seconds. Reconnect power to washer plug in.

After 8 minutes the door will unlock. Gently pull the tab down about 1 4 inch or until a click is heard. See the first image below. We use cookies to give you the best possible experience on our website.

You may also want to test all wiring connections leading to the lock. The control lock light is on as well. The washer door will unlock at the end of the drain. The door can t lock.

During this period you will be able to hear the pump running. Select drain spin to remove any water remaining in the washer. Disconnect the washing machine from the mains grid and inspect the door lock unit for any possible damage. If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.

Replace the door lock switch if defective. Nothing else will appear to be happening with the machine during this time. It would be a good idea to see if no debris has stuck in the door lock unit. Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.

Fresh hold option is on. Unplug the washer and check the door lock assembly for damage or a loose wiring connection. This is a page about unlocking the door on a maytag front load washer. My maytag maxima steam washer door is locked and will not open.

Run a drain and spin cycle. While this option is on the fan blows and the load is tumbled periodically for up to 12 hours. You will have to remove the dispenser bezel trim to access the cord to pull it to open the locked door. Wait approximately 2 minutes for control to reset.

The door can be manually unlocked. Reach up along the inside of the front and locate the bottom of the door switch lock mechanism. The code goes on in case your washer cannot lock the door. Clear any debris out of the door lock assembly.